#Starsat update software products update
This firmware update resolves this issue. Prior to this update, this product would stop receiving audio from another Dante device if left to run for more than 48 days.Dante lock functionality is now supported for Dante parameters.Fixed compatibility issue with host processor firmware when running on hardware using the UltimoX processor.Added option that allows QSC plug-in to discover unD4I-L devices.
Removed double carriage returns on all NACK'd commands.Added configurable control port mode (independent VLANs).Added AES67 support for devices with UltimoX processors (UXT FW: v4.1.4.2).Resolved issue with input hum on restart when using phantom-powered microphones.Reset interval was dependent on Dante processor versionĭante/AES67 network audio interface – 4x mic/line inputs with logic IO Release Notes: Corrected issue that caused devices to reset periodically.Added muting between gain changes to minimize audio pops and artifacts.Alternatively, if it is not possible to confirm the exact time the device has reset and booted, the control application should periodically check the current device state and confirm the current settings against any requests made for parameter changes to the device. Workaround: In order to reliably apply commands sent to a device from a controller, it is recommended to wait at least 8 seconds after a device. Preamp controls, phantom power etc)to units within 2 seconds after reset may result in settings not being applied correctly. Sending a device specific parameter command (ex.Workaround: Use –U firmware option and a control system capable of sending 3rd party UDP commands for device specific control. Preamp controls, phantom power, etc) will not work on –C interface products while enrolled in a DDM domain. Device specific parameter control (ex.Added support for Dante Domain Manager compatibility.
If this occurs, contact Attero Tech Tech Support for assistance to correct this issue. On some older hardware, analog outputs may be muted by this update.
#Starsat update software products upgrade
upgrade Ultimo firmware in products using UltimoX to 4.2.2.3.Dante network audio interface – 2x2 mic/line IO Release Notes: